The 7FF0h address is used in sending mode of the receiver.Ī software on tape is provided with the interface: the Yaesu CAT System. The computer RAM from E900h to F0FFh is used by the communication data. By doing so, you can instantly run without starting the program each time you start the MSX, because the RAM is battery backed up so does not lose its contents. The interface RAM is for RAM files on which you can memorize the program to control the receiver. an analog-to-digital converter (S-METER) that allows the computer to measure the relative strength of received signals (AGC voltage), for interactive operation between the computer and the receiver, when so programmed. a 16kB ROM that adds new instructions to MSX-BASIC - see Yaesu BASIC.This cartridge can be used with MSX1 and higher computers. The connection is made with a cable between the 6-pin DIN CAT output at the top of the cartridge and the 6-pin CAT input of the device, whose internal interface uses the RS-232C protocol. It can be used to control some radio-communication devices (receivers and transceivers), especially these models: Yaesu FRG-965, FRG-9600, FT-736R, FT-767. The Yaesu FIF-MX is a digital CAT interface unit released in 1986.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |